Click image to view full size image
Furnace Charging I:
The first step in the production of any heat is to select the grade of steel to be made. Usually a schedule is developed prior to each production shift. Thus the melter will know in advance the schedule for his shift. The scrap yard operator will prepare buckets of scrap according to the needs of the melter. Preparation of the charge bucket is an important operation, not only to ensure proper melt-in chemistry but also to ensure good melting conditions. The scrap must be layered in the bucket according to size and density to promote the rapid formation of a liquid pool of steel in the hearth while providing protection for the sidewalls and roof from electric arc radiation. Other considerations include minimization of scrap cave-ins which can break electrodes and ensuring that large heavy pieces of scrap.do not lie directly in front of burner ports which would result in blow-back of the flame onto the water cooled panels. The charge can include lime and carbon or these can be injected into the furnace during the heat. Many operations add some lime and carbon in the scrap bucket and supplement this with injection.
Furnace Charging II:
The first step in any tap-to-tap cycle is "charging" into the scrap. The roof and electrodes are raised and are swung to the side of the furnace to allow the scrap charging crane to move a full bucket of scrap into place over the furnace. The bucket bottom is usually a clam shell design . i.e. the bucket opens up by retracting two segments on the bottom of the bucket. The scrap falls into the furnace and the scrap crane removes the scrap bucket. The roof and electrodes swing back into place over the furnace. The roof is lowered and then the electrodes are lowered to strike an arc on the scrap. This commences the melting portion of the cycle. The number of charge buckets of scrap required to produce a heat of steel is dependent primarily on the volume of the furnace and the scrap density. Most modern furnaces are designed to operate with a minimum of back-charges. This is advantageous because charging is a dead-time where the furnace does not have power on and therefore is not melting. Minimizing these dead-times helps to maximize the productivity of the furnace. In addition, energy is lost every time the furnace roof is opened. This can amount to 1020 kWh/ton for each occurrence. Most operations aim for 2 to 3 buckets of scrap per heat and will attempt to blend their scrap to meet this requirement. Some operations achieve a single bucket charge. Continuous charging operations eliminate the charging cycle.
http://www.ttwycasting.com/